pfSense firewall log analyzer facilitates the collection, monitoring, and analysis of pfSense logs to help simplify security audits and expedite threat remediation. A powerful pfSense log analyzer is essential for holistic pfSense reporting.
Issues with upload speed frequently end up being issues with the MTU. If the MTU on pfSense® software (default 1500), is higher than the MTU of the upstream link, it can result in packets being fragmented, lost, or otherwise mishandled. Setting MSS clamping on the WANs or changing the MTU of the interface may help. Pfsense seems to cutting the speed in half. Reading other users the SG-5100 works best with gigabit and has resolved these issues for others. I hope we can figure out what is causing the slow down. So while I have not resolved the slow speed in the VM issue, I am sticking a pin in that for now, so I can get my pfsense up and running. Before re-configuring the OpenVPN in this new hard drive, I decided to try bridging the 3 interfaces that will be used for the LAN side of things. r/PFSENSE: The pfSense® project is a powerful open source firewall and routing platform based on FreeBSD. For some reason it has always been slow when resolving pfSense and Gigabit Internet- Slow Speeds I just upgraded to gigabit internet. When I connect my computer directly to the modem, I get ~800 mbps down. However, when I connect to my home LAN (over wifi or wired), I get around 350-480 mbps (it's highly variable). pfSense version 2.4.2, fresh install. Now, I've also configured the machine with: 2x Single port Intel PRO1000 CT (I think, will verify model at home later) And the issue persisted, got the same results, 100mbps or less. This was all with a fresh install of pfSense, no fancy configs or anything. This can lead to a network card under performing with the default network settings on pfSense® software, as noted on #4821 and FreeBSD PR 203856. Adding a System Tunable or loader.conf.local entry for net.isr.dispatch=deferred can lead to performance gains on such systems.
Jun 22, 2020
pfSense slow site-to-site VPN | MangoLassi
Gateway Group slow (or never) to switch back to Tier 1: 08/14/2019 02:39 PM: 8743: pfSense: Todo: Gateways: New: Low: Gateway Groups page should list gateways in tier order: 08/14/2019 12:16 PM: Give pfSense the possibility to change the keyboard Layout for console users: 12/04/2019 02:20 AM: 4503: pfSense Packages: Feature: New Package
Why squid is so slow? Answer: The default configuration of pfSense is a router not as a server, that is why kern.ipc.nmbclusters="0". Simply remove this line and Squid will be just fine. Add the lines below to the /boot/loader.conf kern.ipc.nmbclusters=32768 kern.maxfiles=65536 kern.maxfilesperproc=32768 net.inet.ip.portrange.last=65535 pfSense slow site-to-site VPN | MangoLassi